You must be logged in and verified to contact the designer.
This is a higher detail full face helmet than is included with the Axial vehicles. It fits most of the axial interiors that have a molded figure in them. You may need to clean out the screw hole with a small drill bit if it is packed with loose powder from the printing process.
The air hose is designed to use standard nitro fuel tubing and push onto an m3x10mm set screw.
This helmet benefits greatly from a little sanding and a few coats of paint!
The painted helmet shown in the photos was painted as recieved from shapeways in white natural versatile plastic. no sanding was used. a few minutes with 400 grit sandpaper and a little bit of primer would greatly smooth the surface finish.