Click and drag to rotate
40mm Round Wound Tracking Base 3d printed

Not a Photo

White Natural Versatile Plastic
40mm Round Wound Tracking Base 3d printed
40mm Round Wound Tracking Base 3d printed

Not a Photo

40mm Round Wound Tracking Base

Made by
3D printed in white nylon plastic with a matte finish and slight grainy feel.

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description
One 40mm diameter round base. Perfect for monsters, robots, or vehicles. Contains a disk to be secured to the underside of the base which is numbered from 1 to 10 to track wounds or damage to the model. No more dice next to your models!

NOTE: Some assembly required and a cyanoacrylate glue is recommended. Always test-fit before assembly. While you do want some friction to keep the disk from spinning freely, too much may prevent it from turning at all. Due to minute imperfections in printing, you may need to lightly sand the edges of the disk if the fit is too tight. When assembling, be sure to only apply glue to where the peg on the under side of the main base will contact the cap piece. Be careful not to glue the rotating tracker disk in place! You will only need a small amount of glue and excess glue may seep out and end up adhering to the rotating disk. The cap is designed to account for some excess, but when it comes to super glue you don't need much. "A little dab'll do ya."
What's in the box:
40mm round 10w
7.89 x 0.3 x 4 cm
Switch to inches
3.11 x 0.12 x 1.57 inches
Switch to cm
Success Rate:
First To try.
What's this?
Mature audiences only.


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.