This necklace/earring hanger is designed to allow for efficient upcycling of circuit boards into jewelry.
Overall dimensions: 20mm wide, 40 mm tall
Will hold circuit board cut approx 16mm wide, 33mm tall
Other materials needed:
Circuit board
Dremel drill or hacksaw
Craft glue (NOT HOT GLUE)
Clear coat (such as Mod Podge)
1) Cut circuit board
Cut circuit board to approx 16mm wide 23mm tall (or 16mm wide, 33mm tall for long version)
2) Verify fit
Ensure circuit board will fit neatly into the necklace hanger
3) Apply craft glue
Use a small amount of craft glue to attach the circuit board inside of the hanger. Glue should not bleed out the sides - if it does, use a cloth to remove excess.
Allow sufficient time to dry before performing next step. Refer to glue instructions.
4) Apply clear coat
After glue has dried, apply clear coat.
Allow sufficient time for clear coat to dry.
5) Add hardware, chain or earring posts
After clear coat has dried, attach necklace/earring hardware and chain