Click and drag to rotate
7mm Basic Set - NSWR Small Station Signs 3d printed

Not a Photo

Smooth Fine Detail Plastic
7mm Basic Set - NSWR Small Station Signs 3d printed
7mm Basic Set - NSWR Small Station Signs 3d printed

Not a Photo

7mm Basic Set - NSWR Small Station Signs

Made by
3D printed in matte translucent plastic that showcases fine and intricate details.

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description
This is a 'basic' set of small wall mounted NSWGR station signs consisting of:

STATION MASTER                                   BOOKING OFFICE
PARCELS OFFICE                                    WAITING ROOM
LADIES TOILET                                           LADIES
GENTLEMEN                                               MEN

Included are two variations of toilet signs.

The short signs sometimes only have a bracket underneath, in this case the upper bracket can be easily removed.

The signs are painted in several ways and it is best to refer to photographs of actual stations. Some are all white with black text, others have a black background to the white text with a white surround to the sign.

The signs should be sprayed with an air brush to achieve a very thin coating of the background colour.

If the background is white then the black text can be achieved with a fine pointed 'Sharpie' permanent ink pen held so that the tapered edge wipes across the lettering and perhaps the tmber sign edging depending on the style chosen.

If the background is black then a white text effect could be achieved by scraping the black paint from the tops of the text with a new flat edged blade. Although the Smooth Fine Detail Plastic is translucent a white effect can be caused by the scraping of the surface.

Alternatively the sign could be sprayed with a thin coat of white then it would need to be allowed to harden for a few days. After this black  paint can be carefully applied to the back ground and after drying the black can be scraped away with the edge of a sharp blade to reveal the white lettering.

Cut the signs from the sprue at the joint with the sprue, this will leave a 1 mm diameter mounting peg. Drill a 1 mm hole and glue in place.

Please note that the signs are 1.4mm thick and as most signs are under the awning of the station building they will be out of the way and safe from the possibility of breakage. If a sign is on a wall of the building outside the awning it is suggested that the sign be mounted without glue for possible replacement if broken during handling of the building.
What's in the box:
7mm Scale Basic Station Signs v5
3.78 x 15.73 x 0.4 cm
Switch to inches
1.49 x 6.19 x 0.16 inches
Switch to cm
Success Rate:
First To try.
What's this?
Mature audiences only.


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.