You must be logged in and verified to contact the designer.
This is a bezel for use with the 1.8" TFT Display module which includes a full-sized SD card slot on the reverse side. This bezel is intended to be used on the edge of your project enclosure containing your microcontroller and wiring. Use the first Image as a reference. Basically, you cut out a portion of the side wall and top wall of your enclosure, then place the bezel over the cutout, hiding the cuts you've made(keeping things looking clean) and allowing you to see the display and insert and remove an SD card without issue! This is perfect for things like robots, 3D printers, CNC machines, DIY disk drive plotters, and so on. All of the edges are rounded, and the display border and non-functioning areas of the screen are covered, revealing only the portion of the screen that displays. On the back of the bezel, there are 4 posts which fit into the screw holes of the display module, these posts can then be melted down with a soldering iron or similar to hold the display in place. You can also simply epoxy the display into place after fitting the screen into the designated recessed area.