Click and drag to rotate
LandRoverS1 88 1 30 B 3d printed

Not a Photo

White Natural Versatile Plastic
LandRoverS1 88 1 30 B 3d printed
LandRoverS1 88 1 30 B 3d printed

Not a Photo

LandRoverS1 88 1 30 B

Made by
3D printed in white nylon plastic with a matte finish and slight grainy feel.

Have a question about this product?

contact the designer
You must be logged in and verified to contact the designer.
Product Description
p { margin-bottom: 0.1in; line-height: 120%; }A 1:30 scale model of a Land Rover s1 with opening door 'kit', rotating wheels, steering wheel and exchangeable hoods. The model includes a snap together door hinge mechanism to allow the doors to open and close and snap-in window glass so, if printed in opaque plastic, the 'glass' could be replaced with a clear foil, purchased separately and cut to size . This 3D print can be displayed as an open top, soft top or hard top model or even as an SAS style doorless vehicle.

The door parts are on a sprue attached to the removable hard top. Simply cut out the parts, with wire cutters or a craft knife. Place the doors in place, slide in the 'hinge pins' from below then slide the locating bar (to which the hinge pins were attached) into the slot in the chassis. For the clear glazing any clear foil, such as overhead projection foil is suitable, cut to size using the two rectangles attached to the hard top as a guide. If required any 'kit' parts could be held in place with a dab of Super Glue.

What's in the box:
LandRoverS1 88 1 30 B
5.61 x 11.9 x 10.71 cm
Switch to inches
2.21 x 4.69 x 4.22 inches
Switch to cm
Success Rate:
First To try.
What's this?
Mature audiences only.


We're sorry to inform you that we no longer support this browser and can't confirm that everything will work as expected. For the best Shapeways experience, please use one of the following browsers:

Click anywhere outside this window to continue.