<div id="cookie_notice" class="sw-cookie-notice sw--padding-vert-4 sw--padding-hor-1 sw-dms--box-shadow--big">
<div class="sw-dms--color-white sw-grid-flex sw-grid-flex--wrap-mob sw-grid-flex--wrap--tab">
<div class="sw-cookie-notice__text--mob sw--padding-left-8 sw--font-size-14 sw-grid-flex__cell-5-7 sw-grid-flex__cell-1-1--mob sw-grid-flex__cell-1-1--tab">
<div class="sw-grid-flex__cell-2-7 sw-grid-flex__cell-1-1--mob sw-grid-flex__cell-1-1--tab">
<a class="sw-dms-button noty_close sw--padding-hor-7 sw--position-absolute sw--position-right sw--margin-right-13 sw--hide-mobile sw--hide-tablet" data-sw-set-cookie="euCookie">OK</a>
<a class="sw-cookie-notice__btn--mob sw-cookie-notice__btn--tab sw-dms-button noty_close sw--padding-hor-7 sw--margin-vert-3 sw--hide-desktop" data-sw-set-cookie="euCookie">OK</a>
3D printed in matte translucent plastic that showcases fine and intricate details.
1/192 scale very hi detailed and accurate model of 3'' /50 [7.62 Cm] Caliber AA Deck Gun for U.S. Navy ships.
Ship Class Used On: Many ships 1915 through 1945
A series of 3" (7.62 cm) AA guns dating back to World War I. These were of a simpler construction than the previous 3" (7.62 cm) guns and successive marks were to improved designs. This gun was widely used up to the 1930s, but were then gradually replaced on larger ships by 5"/25 (12.7 cm) single mountings and later by Bofors 40 mm in twin and quad mountings. However, the battleships New York and Arkansas still had them as late as 1943. During World War II this weapon was extensively used on smaller warships such as destroyer escorts, submarines and auxiliaries along with many merchant ships with about 14,000 guns being produced between 1940 and 1945.
Real scaled from original
Hollowed to saved material
If you need a different size or a custom part designed just for you?
Please send me a PM.
Some part cleanup will be necessary. The 3D printing process uses a waxy substance to support certain part features. Although the parts are cleaned by Shapeways, some waxy residue may remain. It can be safely removed with water and a mild aqueous detergent like "Simple Green" using an old, soft toothbrush, Q-tips or pipe cleaners. Customers report that "Bestine" and "Goo Gone" also work well.
During the printing process, liquid resin is cured by ultraviolet light. Microscopic bits of resin may remain uncured. Let your parts sit in direct sunlight for a few hours to fully cure the resin.
Water-based acrylic paints meant for plastics is strongly recommended. Other paints, especially enamels, may not cure on Frosted Detail 3D-printed plastics.