1/700 Scale Modern US LAV-300 Tank Destroyers.
Contains 10 highly detailed tanks.
Contains:- 10x US LAV-300 Tank Destroyers
LAV-300 Tank Destroyer
The
Cadillac Gage Textron LAV-300, originally named as the V-300, is a family of American light armored vehicles (LAVs) including up to 15 configurations. LAV-300 offers high mobility, speeds of up to 65 mph (105 km/h), and can be air-transported by a
C-5 Galaxy,
C-141 Starlifter,
C-17 Globemaster III and
C-130 Hercules cargo aircraft. Some versions can be air-transported by
CH-53E Super Stallion helicopter.The LAV-300
6x6 series is the complement to Textron’s Marine and Land Division’s (formally Cadillac Gage) 4x4
Commando series. The Philippine Marines were supplied with an
armored personnel carrier (APC) version with a turret armed with a
.50 caliber and
7.62 mm machine gun and a fire support version armed with a Cockerill 90mm cannon. The
Marine Corps had wanted the US-built
LVTP7A1 (now called the
AAVP-7A1) amphibious armored landing vehicle, and 36 vehicles were offered in the 1980s; however, partisan political and financial interests shot down the deal. Instead, V-150s were secured through FMS. In 1991, LAV-300s were proposed as the Philippine Marine Corps' share in the US bases compensation package. The Marines accepted them but mandated modifications to better suit their needs:
pump jets for amphibious operations, a rear ramp for the easier discharge of troops, and a trim-vane. Smoke grenade launchers and the
winch were scrapped to trim costs.
Most of Kuwait's LAV-300s were destroyed by Iraqi troops during the
1990 Invasion of Kuwait.
Cleaning Information
Some part cleanup will be necessary. The 3D printing process uses a waxy substance to support certain part features during the printing process. Although the parts are cleaned by Shapeways, some waxy residue may remain. It can be safely removed with water and a mild aqueous detergent like "Simple Green" using an old, soft toothbrush, Q-tips or pipe cleaners. During the printing process, liquid resin is cured by ultraviolet light. Microscopic bits of resin may remain uncured.
Let your parts sit in direct sunlight for a few hours to fully cure the resin.
Water-based acrylic paints meant for plastics is strongly recommended. Other paints, especially enamels, may not cure on Frosted Detail 3D-printed plastics.
Use dedicated model sprue cutters to remove parts to minimise the risk of damage to parts.
Please take a look at my other items.
Painting tips and preparation