Mask of Ultimate Power (LEGO edition&runes)

The Mask of Ultimate Power|TITAN SCALE|runes

I entrusted myself with the responsibility of making the mask as if it were produced by LEGO.

As you can see from the inside, I tried to make it completely the same shape if the model had completely gone through the process of pouring plastic into the mould and then found itself among a pile of plastic, in a container.
At every stage of the work on the model, I had a lot of difficulties, for example: the wrong set of references, small mistakes not matching the original shape of the mask, an unnatural neckline for the eyes that only this mask has, which makes the eye holes barely visible. There were problems with the inside of the mask, and I deliberately put Lego rods instead of pistons. In the original model, the pistons are slightly thicker, so I can say that I played along with the wishes of mocmakers. And how many prototypes were printed to ensure the quality of the model.

The biggest challenge for me was the form factor, I thought the mask model was bigger than it should be, and my first printed prototypes were much smaller than the real size. I did not really want titan size, but after listening to many people, I decided it was better to leave it as it is.