DJI Phantom Zenmuse FPV Undertray (Dual Battery)

This is the d3wey Zenmuse H3-2D FPV Undertray with Dual Battery capability for the DJI Phantom.

It is designed around the Zenmuse H3-2D gimbal and the Fatshark Predator V2 kit but can be used for other vTX's (please check measurements).

This version has the 'dual battery table'. This is designed for my Battery Cage's (NOT INCLUDED see other items) but can be used for other items such as OSD's etc. With 2 x 2200mah batteries in this configeration you can expect about 10mins flight time on stock blades. If you use the larger battery cage with 2250+ batts you may manage more (depending on your voltage protection levels and battery condition).

The tray is fitted to the Phantom via "4 x M3 25mm Brass Hex Spacers" (not included). They can be sourced from Ebay for about £2 - £3.

The spacers replace the inner screw on each of the Phantom's landing legs. The tray then sits on the spacers and the original M3 leg screws are used to attach the tray to the spacers.

The TX slides into the custom slot and is fixed in place with the supplied door which can either be sealed with small nuts/bolts (not supplied) or string/wire.

The internal dimensions of the TX holder are:

• Width: 27mm
• Height: 13mm
• Depth: 56mm

This listing is for the Undertray only... Battery Cage and the Fatshark Filter Housing mounted are available to be purchased seperateley in the shope in different specs

Videos are here:

Non Dual Battery Install

Dual Battery Setup

*** - Please Note - *** As with any Shapeways product please be aware of what you are buying. This is a custom designed part not mass produced. It has a slighty rough finish (but nothing that will scratch items). I make every effort to test all my designs but I regret manufacturers do change their products from time to time. If in doubt please contact me.

- d3wey -