Mt. Washington, the highest peak in the Northeastern United States, is probably best-known for
holding the world record for highest measured wind speed on land of 231 mph, measured in 1934;
though that record was surpassed in 1996 by a gust of 253 mph on Barrow Island, Australia.
Mt. Washington was the one of the nation's first tourist destinations, with a summit house
(creatively called "Summit House") being erected in 1852, a cog railway (still in use) in 1869,
auto road in 1861, and numerous trails, hotels, and attractions in the area.
At the mountain's Western foot is the Mt. Washington Hotel, site of the important Bretton Woods
Conference which, in 1944, laid out the international monetary and financial system that is still
in use today.
Our model of Mt. Washington focuses on the Eastern slope, but includes many of the Presidentials
from Mt. Monroe to the Southwest, through Washington, Jefferson, Adams, Quincy Adams, and Madison
to the far North. The Southeast corner features Wildcat Mountain and its complete ski area.
Famous features included in this model are: Tuckerman Ravine, Pinkham Notch, Boott Spur, Huntington
Ravine, and the numerous beautiful alpine meadows. On the larger models, you can even trace the
popular Mount Washington Auto Road, site of one of the oldest auto races in the USA, and source
the ubiquitous "This car climbed Mt. Washington" bumper stickers.
Whether it's for historical, adventure, or sentimental reasons, we hope you'll enjoy this
accurate model of New Hampshire's gem, Mount Washington, in your home, office, or backpack.
Model scale is 1:150000
Model covers an area approximately 7 by 7 miles
Altitudes covered: 1120' to 6288'
There is no vertical exaggeration in this model: it is a true scale model of the area.
Click here for more sizes.
Click here for other 3" models.
TinyMtn models are most affordable in the "White Strong and Flexible" and "Sandstone" materials. This model is in "White Strong and Flexible." When you receive the model, there may still be Nylon dust on it from the printing process. Use either an airbrush, canned dust blower, or a soft old toothbrush to remove this dust. Do not get the "White Strong and Flexible" material wet, and don't prime it or use any oil-based paints on it. You can safely seal it with Polycrylic or a similar water-based clear spray sealant. Read more about this popular material here.
The "Frosted Detail" material will show more detail, but is semi-transparent and has an uneven surface texture when unpainted (due to the orientation of the model when Shapeways prints it). It may show up feeling a little greasy and with small crystals in crevasses. Clean those off by soaking the model in warm (but not hot) soapy water and brushing with an old toothbrush. To get the surface to an even matte finish, spray with a few light coats of sandable primer (white automotive primer works), and then do a baking soda grit-blast.
These models have been optimized for the above materials, and are not offered in other materials for strength or cost reasons. If you need one in another material, please contact us and we'll try to accommodate your request.
(C) 2015 TinyMtn (TM)
Model created using GDAL, NetPBM, Gmsh, Carve, MeshLab, and other custom software
Source of digital elevation data: U.S. Geological Survey
The USGS home page is http://www.usgs.gov/