Zcorp z400 Revival!

Discussion in 'General Discussion' started by Wofforduk, May 23, 2012.

  1. Wofforduk
    Wofforduk New Member
    Hi All

    I am a newbie here... as i would love to get more involved into the world of 3d printing! i have had the chance to pick up a couple of printers for not a lot - both with their problems.. but the z400hopefully shouldnt be too much of a mission!

    I am told that i have a problem with the fast axis, i have read up on another thread that they are common to go 1st.

    I have hooked it up to a monitor - it does its checks to the fast axis then at the end says 'waiting for error to go to 0' which.. it stays at 1.

    has anyone had any experience? or have any spare parts?

    Thanks!!!


     
  2. stonysmith
    stonysmith Well-Known Member Moderator
    This may not be the best place to ask this question. Shapeways is a service bureau and they own the printers. There may be a few Shapeways members that have experience with their own printer, but most of the community does not own a printer.
     
  3. Wofforduk
    Wofforduk New Member
    Oh okay thanks stonysmith, its worth a shot hey! im uk based so i doubt i will be of much threat :)


    Thanks
     
  4. crsdfr
    crsdfr New Member
  5. Wofforduk
    Wofforduk New Member
    Thanks crsdfr!!

    Ill give them a go!

    Thanks all

    W