You've been sneaking stuff in again !

Discussion in 'General Discussion' started by tebee, Jun 13, 2012.

  1. tebee
    tebee Well-Known Member
    Unless i've missed the announcement of this there is a new feature been introduced without telling us.

    I've just uploaded a model and noticed some of the materials have a red square with an exclamation mark on them .

    If you mouseover them it says " Warning: This model has failed our Automated Wall Thickness check and may be rejected during 3D printing in this material"

    Nice one Shapeways !

  2. WillLaPuerta
    WillLaPuerta Well-Known Member
    Last edited: Jun 13, 2012
  3. stop4stuff
    stop4stuff Well-Known Member
    Yep that one was on the list, as well, something elseI spotted today - the software also check for mm/inch uploader errors :blush: :rolleyes: