Worm gear needed - see technical drawing

Discussion in '3D Design Requests' started by timpmandan, Jul 27, 2012.

  1. timpmandan
    timpmandan New Member
    Hello all,
    I'm very new to this whole 3d printing thing, but I'm betting it will work for a particular part I need replaced in a vintage Bodine motor. The right angle worm gear was mashed on 3 teeth and I found an original technical drawing that gives every detail needed. I'm curious if I could convince someone to give this a shot for me? I can tap the set screw holes if printing threads is not easy. See drawing.
     

    Attached Files: