Using STL files Help required!

Discussion in 'Software and Applications' started by basilwatson, Dec 10, 2009.

  1. basilwatson
    basilwatson New Member
    I use varicad for 3d

    I drew a manifold , and its not very watertight

    I then used various meshing programs , meshlabs, Gmsh, netgen

    I use these for Calculix ( an engineering software )

    The manifold meshed well in Netgen and Gmsh

    but in Blender if was 100 non manifold , full of problems ( 1 or 2 I can accept but this would be quicker to redraw ! )

    So it maybe the output of Varicad ?

    anyway any suggestions to produce a watertight drawing?

    Stephen model.jpg
     
  2. bartv
    bartv New Member
    Hi Stephen,

    it's hard to tell from an image - could you send the file to service@shapeways.com? We'll see what we can do for you.

    Cheers,

    Bart