Using Instancing in VRML files allowed?

Discussion in 'Bug Reporting' started by wedge, Feb 14, 2013.

  1. wedge
    wedge New Member

    I have a question about the Process and VRML files.

    I Uploaded a VRML file, replacing an older Model. Because off filesize I used the Instancing of VRML usung the "USE" Statement.
    After Uploading the file I got a Mail
    But with no further information.
    Also my Model page was away.
    So I uploaded the Model again without the USE statement. Everything was fine, I Orderd.
    Some hours later I Got a mail ...

    Two Question:
    1. Is it Good or not Good to use the USE Statement in VRML.
    2. For interest: Was the model manualy rework?

    The Model is not public visible. So I want post a link here ... but if you have access to my models it was XmasPrintTestALU 1.0 (I wanted replace my old test print file with new cool Product-Test ;) )
  2. natalia
    natalia New Member

    Before I forward your question to Customer Service, can you clarify a little bit about what you are asking?

    What was your second email? That it was fine to print?

    Please also note that the image takes a moment to re-fresh when you have updated the STL file.

  3. wedge
    wedge New Member
    Yup after 8 hours I got the 2nd mail an the Model was ready to Print.
    In this time it was complettly gone of the site "My Models".

    So I upladed a version without VRML-Instancing, and this Version was ready in Minutes, like normal.
  4. natalia
    natalia New Member