Turn engraving into a hole

Discussion in 'Design and Modeling' started by a3333326, Nov 18, 2012.

  1. a3333326
    a3333326 New Member
    Hi,

    I was wondering is it possible to turn an engraving into a hole? Such that it not just an engrave on a ring but something like an extraction.

    Thank you very much.

    Regards,
    Wade
     
  2. Fredd
    Fredd New Member
    There is a tool in some programs called Boolean difference modifier. For example you could have a manifold cube with a manifold cylinder bisecting it, run the boolean, result would be just the cube and a tunnel running through it, if this is what you need.