Thickness Changes

Discussion in 'General Discussion' started by jeremyzschau, Mar 19, 2013.

  1. jeremyzschau
    jeremyzschau New Member
    I use Strata 3D CX 7. When different parts intersect the thickness goes under minimum. My knot lid, tall ochoko and expanding ochoko all have parts that are below the minimum thickness but they were printed fine.
     

    Attached Files:

  2. jeremyzschau
    jeremyzschau New Member
    Capture.JPG Another example.
     
  3. Youknowwho4eva
    Youknowwho4eva Shapeways Employee Community Team
    What material are you printing in? Our checks are manual, so just because something got through our checks doesn't mean that it fully complies with the rules.
     
  4. stonysmith
    stonysmith Well-Known Member Moderator
  5. jeremyzschau
    jeremyzschau New Member
  6. jeremyzschau
    jeremyzschau New Member
    I ran the models through the netfabb website. I will ask Shapeways staff to check. Thank you.
     
  7. jeremyzschau
    jeremyzschau New Member
    It printed. Thank you so much. It's on my shop now.
     
  8. UniverseBecoming
    UniverseBecoming Well-Known Member
    I love the design! Props! :eek: