Printing Of 0.5mm Thick Engine Fins ?

Discussion in 'Design and Modeling' started by LEPICARD7, Oct 8, 2017.

  1. LEPICARD7
    LEPICARD7 New Member
    Last edited: Oct 12, 2017
  2. IntelXeon
    IntelXeon Well-Known Member
    needs to be atleast 0,7mm or shapeways wont print it at all
     
  3. mkroeker
    mkroeker Well-Known Member
    You can try by ticking the "print it anyway" checkbox in the shopping cart (but then you will get no reprint or refund if the print actually breaks). My guess is that they will actually print correctly, but may easily get damaged during cleaning. (Remember your model will be one of many stacked within a caked block of nylon dust. Somebody has to pick it up and remove all the powder that clings to it)