nothing special

Discussion in 'Technologies and Hardware' started by pdb, Apr 14, 2012.

  1. pdb
    pdb New Member
    hey

    just a post to show a print error for customer services
    nothing interesting here

    print error.jpg
     
  2. DarioScapittaDesign
    DarioScapittaDesign New Member
    :eek: Really???...

    They HAVE TO pay attention at this kind of error, try again!!

    Good luck! :(
    Dario
     
  3. stonysmith
    stonysmith Well-Known Member Moderator
    If your STL file has a "hole" in it, it's possible that the hole was filled by the automatic software incorrectly. In Netfabb, click Repair and see if anything shows up needing to be fixed.
     
  4. pdb
    pdb New Member
    im not to bothered the drawing wasnt up to spec in the first place. logo hole wasnt in the right place......so a re print is needed anyways.

    :)

    i have run the the 'import diagnostic' in solid works, message reads ' No faulty faces or gaps remain in the geometry'

    so doubt its that.....thanks for the suggestion though