Need To Make A Large Hole In A Model

Discussion in '3D Design Requests' started by StyreneLunchbox, Jun 13, 2018.

  1. Hello. I've got what's hopefully a straightforward request. I need to make a large hole in the center of a model to make it more screen accurate while also hopefully cutting down on material cost. The hole needs to go in the orange colored section, and penetrate all the way through to the bottom (the model is flipped for some reason after fixing so the side facing up is actually the bottom. I flipped it right side up in my screenshot.). If someone would like to give it a shot, please lemme know with estimated cost. Thanks.
     

    Attached Files:

  2. Frozenrain
    Frozenrain Well-Known Member
    pm sent:)
     
  3. astonetech
    astonetech Member
    Here is the screen shot as per your requirement.
     

    Attached Files:

  4. Job taken care of! Thank you to everyone who replied!