Need Modeler for "Christmas Ornament" tpe project

Discussion in '3D Design Requests' started by gaaypdx, Nov 9, 2011.

  1. gaaypdx
    gaaypdx New Member
    Looking for lightweight ball shaped open design, logo on one side and rose on other side (if possible)- "see through" hollow style and hanger/connector on top. (low definition of two sides attached). Must be clean and ready to upload to Shapeways for production as I have NO competency, just ideas. These are holiday gifts for a non-profit in 2012. SSeibert@LHS.org ball.JPG
     
    Last edited: Nov 9, 2011
  2. mctrivia
    mctrivia New Member
    can not be made clear on shapeways. could be made of colored sand stone.

    1 1/4" ball diameter would cost about $6 each. can make model for $15 but you need to give me proper dimensions for hanger neck as I don't have any
     
    Last edited: Nov 9, 2011