Need a 3D scan and enlargement

Discussion in '3D Design Requests' started by msclu31, Apr 18, 2013.

  1. msclu31
    msclu31 New Member
    I have a part that I would like to get scanned/duplicated (it is less than 4"x4"x4") and then have it reproduced 10% larger. Any estimates on cost and turnaround time? PM me and let me know. Thank you.
  2. CADNinja
    CADNinja Well-Known Member
    Private Message Sent
  3. designanything3d
    designanything3d New Member
  4. pfeifferstylez
    pfeifferstylez New Member