model could not be print (i use SketchUp)

Discussion in 'General Discussion' started by cnomis, Mar 18, 2013.

  1. cnomis
    cnomis New Member
    :blush: i m newbie of here & SketchUp either, i wanna do a ball joints (like that use on Revotech toys)connect around a spin.

    after lots of study, i hollow 6 hole on the spin, however, due to the thin wall issue, it could not be printed. i dunno how to fix it in my limited knowledge of 3D. so i post & hope u seniors could advice or fix it for me.

    i just miss this one to complete my set, so poor. i ll appreciate if any one help. thx a lot.

    here s the file:

    https://dl.dropbox.com/u/618217/Set_axis.skp
     

    Attached Files: