Missing face on "My Design" page

Discussion in 'Software and Applications' started by theclonefactory, Mar 28, 2011.

  1. theclonefactory
    theclonefactory New Member
    I just uploaded a model and noticed that a face is missing on the default picture under "My Designs"

    http://www.shapeways.com/model/232336/arc_pauldorn__v_1_.htm l?gid=ug45133

    it should appear on the right hand, top side, where it appears you can look through the model.

    I uploaded the model twice but get the same result.

    This face is present in sketchup, meshlab and accutrans. :(
     
    Last edited: Mar 28, 2011
  2. bartv
    bartv New Member
    Your model is set to private so we can't see it. If you mail the file to bart@shapeways.com, then I'll check it out for you.

    Cheers,

    Bart
     
  3. Piggy
    Piggy New Member
    Is it perhaps an inverted normal that for some reason doesn't get shown?
     
  4. theclonefactory
    theclonefactory New Member
    Actually it was because my modeling skills are crap. :( But they are improving. :)

    Thank you for the help.