Minimum Dimensions

Discussion in 'Technologies and Hardware' started by AyameDeude, Jan 9, 2012.

  1. AyameDeude
    AyameDeude New Member
    Hello fellow Shapies!

    I submitted an order for one of my models so I could take some photos and I received a "dimensions too small" notice about it.

    As far as I can tell, the dimensions of both earrings fit in the minimum 65mm total. Though, admittedly, only when accounting for both earrings.

    Link to model: http://www.shapeways.com/model/426629/minecraft_earrings__gr ass_.html?gid=ug

    Is there something I'm missing or is it a mistake? I can increase the size of the earrings easily enough, but I really like the current size of them and am worried that it will come out gaudy.

    Note: the original design was two cubes of 16x16x16mm each. i recently ugraded them to be 22x22x22mm in hopes that it would fulfill the 65mm minimum.
     
    Last edited: Jan 9, 2012