Mesh Help Please

Discussion in 'Design and Modeling' started by Harrison2836, May 2, 2012.

  1. Harrison2836
    Harrison2836 New Member
    Hi All,

    I have been trying to fix my model for a week now, with no avail.
    Rhino mesh edit said it was all good meshes.
    Net Fab Basic has no issues,
    All wall thicknesses are within the limits ranging from 1mm to 3mm

    Yet I am still unable to print.

    Any help would be very much appreciated

    Thank you in advance

    Attached Files:

  2. stop4stuff
    stop4stuff Well-Known Member
    First hit, using NetFabb's analysis tool;
    12 holes
    154 boundary edges
    Using NetFabb's repair tools results in the same, exporting the repaired part and re-loading results in the same.

    2nd hit, using NetFabb cloud service ( returns a printable model with two shells - this means all of the 187 shells in the original model have been reduced to the least amount of seperate shells possible and that you have two seperate parts in your model. This model is attached.

    If you intended two parts then ignore this - identify the loose part & move it slightly to overlap the main part, then use NetFabb Cloud service to merge the two shells into one (upload file then download repaired file)and you should be good to go.


    Attached Files: