Looking for someone to design small case for LCD display

Discussion in '3D Design Requests' started by jaypdx, Feb 13, 2012.

  1. jaypdx
    jaypdx New Member
    I'm looking for someone to design a case for a small LCD display (see pic). The display is a two-board stack that's roughly 2.5x3.0x1.0" overall. I'm imagining a two-piece design that would snap or screw together. There are four holes on the lower board available for mounting purposes. I can provide detailed dimensions of the assembly (including some in DXF). I haven't thought much about the material, but probably some kind of plastic would be fine.

    I don't have much of a budget for this (it's just a little hobby project), but I'm also not sure I want to dive into learning new software and trying to design it myself.

    - Jay

  2. mctrivia
    mctrivia New Member
    Will design for $10
  3. captainkynan
    captainkynan New Member
    If you could send the DXF and detailed info I'll give it a go and see if you like it...
    Are you after a particular style, or just a box?
  4. Max0007
    Max0007 New Member
    I would also like to give it a shot :p

    So if there´s still a place you can send me the dxf over as well.