Mitchell at Shapeways suggested i post these new scales I made for a Leatherman Squirt Keychain tool. Long have a had a hatred for the soft aluminum scales that came with the keychain multitool that always get damaged. So I designed some in Sketch up and then several iterations and prototypes later I was able to move up to the 3d printed steel!. I call it the Leatherman Splash, It's no Leatherman Wave, but it sure isn't a Squirt anymore. They are available at my shop: http://www.shapeways.com/shops/metro-qbranch Here you are, these are finsihed a bit with some sandpaper (800 grit set sand) I was even able to design in a couple of slots for some tiny 1.5mmx6mm tritum glow tubes. This one is the wirestripper version, so it's Red/White glow tubes for Pos/Neg... Thanks shapeways for allowing me to really enjoy having my keychain tool on my keys and having it looking great!