Is this too complicated to get rapid prototyped?!

Discussion in 'Design and Modeling' started by Thomasaddison, Apr 16, 2013.

  1. Thomasaddison
    Thomasaddison New Member
    Just wondering if you think this would be possible to rapid prototype or not ?, if not any idea on how i could prototype it!. basically its a disc dropper ^.^

    I've included a pdf with some images, the quality messed up :/ but i hope you get the idea, its 220mm high, 60 mm diameter including square edge sections.
     

    Attached Files:

  2. stonysmith
    stonysmith Well-Known Member Moderator