i'llBuild - mount for iPhone with adapter 4 K'Nex

Discussion in 'My Shapeways Order Arrived' started by pdb, May 2, 2012.

  1. pdb
    pdb New Member
    there's still a few tweaks to be made

    for some reason i didn't remove the material for the camera?!

    and a few fits issues.....as always......theres something im not factoring in when i make the cases........ possibly not accounting for shrinkage.

    but still managed to fit the pieces in the connector. and had a tinker very tight fit though

    when i sell this item in my shop can i use these pictures or will i have to remove the knex and shoot the mount only?

  2. Youknowwho4eva
    Youknowwho4eva Shapeways Employee Community Team
    Awesome dude. Now make one for a Samsung Skyrocket :laughing: . I think the pictures will be fine. Just make sure you say they're not included, and if you call them K'nex you might want to have a disclaimer about K'nex is a copyright of whoever blah blah.
  3. pdb
    pdb New Member

    ill keep that in mind :)
  4. stop4stuff
    stop4stuff Well-Known Member

    Mike, pcb already has a copy of the K'nex legal blub, but the K'nex ppls are a bit... erm... not up to speed (imo) about the whole concept of IP rights & 3D printing :rolleyes: