I need your opinion for some 3d printed models

Discussion in 'General Discussion' started by Jose_narvaez, Feb 4, 2013.

  1. Jose_narvaez
    Jose_narvaez New Member
    Sin título_1.jpg hello community members
    i just recently uploaded my 3d printed models cases for iphones 4 and 5 and lg 5
    iphone 4
    http://shpws.me/mVXA
    iphone 5
    http://shpws.me/n2IC
    lg optimus l5
    http://shpws.me/mVUH

    i just want to ask your opinion if i should reveal the apple´s logo and quit the leaf logo in all of my cases.
    i already did that on my new design for lg optimus l7
    http://shpws.me/ng8s
    what do you think? i want your comments and suggestions about the designs or new suggestions or improvements that
    i should make for this.​
     
  2. stop4stuff
    stop4stuff Well-Known Member
    Last edited: Feb 4, 2013
  3. Jose_narvaez
    Jose_narvaez New Member
    could you explain me that a little more? :D
     
  4. stop4stuff
    stop4stuff Well-Known Member
    Remove the veins from the leaf, make it a bit bigger and place so that the Apple logo can be seen through the middle of the leaf.

    Paul
     
  5. Jose_narvaez
    Jose_narvaez New Member
    that sounds good thanks
     
  6. redpanda608
    redpanda608 New Member
    I agree, placing the leaf logo over the apple logo would be a lot better. :)
     
  7. Jose_narvaez
    Jose_narvaez New Member
    well, thanks for your advice i´m working on that :)