Hi forum

Discussion in 'Newcomers Lounge' started by RuggedBear, Nov 17, 2011.

  1. RuggedBear
    RuggedBear New Member
    Hi all

    I am new to this new technology of modeling and 3d printing and hope that I will be able to do what I set out to achieve.

    I am looking to produce (with the help of an expert) a watch part and hopefully it wont be too much hassle (or money) to get started. More details of my project to follow.


    Last edited: Nov 17, 2011
  2. Youknowwho4eva
    Youknowwho4eva Shapeways Employee Community Team
    Welcome Andy

    What kind of watch part? I've been contemplating making a watch (minus the movement, bought separately) for a while. You can always post in the modeler needed section, and helpful Shapies will be there to assist you.
    Last edited: Nov 17, 2011
  3. RuggedBear
    RuggedBear New Member
    I too have wanted to make my own watch, but for a good eta movement, you are looking at £350 which is what goes into the top of the range watches.

    Im looking to make a rare part and sell it basically. Its a shroud, but need to see if it is possible.