Help fixing a model needed.

Discussion in '3D Design Requests' started by GalacticWierdo, Feb 5, 2012.

  1. GalacticWierdo
    GalacticWierdo New Member
    So I attempted recently to get a model printed, however, there were quite a few problems with it. I got attempted to get assistance from Shapeways, however, they were unable to alleviate the problem. I think that the issue here is that the model is non-manifold perhaps? But I can't find anything wrong. Any help would be appreciated!

    Attached Files:

  2. stop4stuff
    stop4stuff Well-Known Member
    The model was missing all faces, I fixed it with NetFabb Basic by closing all holes.

    The file I attached is an stl binary, let me know if you need it as .stl ascii.


    Attached Files:

  3. GalacticWierdo
    GalacticWierdo New Member
    Thank you so much for your help, it uploaded this time!