Discussion in 'Newcomers Lounge' started by maxenin, Nov 19, 2010.

  1. maxenin
    maxenin New Member

    Im new here well I guess that goes without saying :p but i was wondering if I have a question about the materials under which forum should i put it? thx everyone
  2. Youknowwho4eva
    Youknowwho4eva Shapeways Employee Community Team

    It semi depends on your question. If it's about design limitations, then it would go in the 3D Design. If it's about the material or process, then 3D printing would be the place.