Gun barrel weight \ underlug needed

Discussion in '3D Design Requests' started by inferno, Feb 22, 2012.

  1. inferno
    inferno New Member
    Approximately 6inch long weight needed to be modeled to be added under a revolver pistol barrel. must be precise measurements. can send barrel to model off of.
     
  2. inferno
    inferno New Member
    Sorry, i just realized a 6 inch long piece would be $300+ in stainless steel, so i am cancelling this project.
     
  3. mctrivia
    mctrivia New Member
    can be machined on CNC for much less
     
  4. inferno
    inferno New Member
    do you have any suggestions for where to get this single item CNCd? thanks!
     
  5. animerb
    animerb New Member
    you might look into finding a local gunsmith. they would likely have all the tools needed for such a project
     
  6. Twopounder
    Twopounder New Member
    Yeah, a gunsmith is highly advised, not just for cost/experience reasons, but also safety.