Gaps

Discussion in 'Technologies and Hardware' started by Rogue, Nov 8, 2012.

  1. Rogue
    Rogue New Member
    Hello, I'm currently designing a part that I would like to get printed at shapeways.
    What is the minimum gap that I can have between sections of a part? (think of long slit for venting that is very thin). I know that on some printers if the gap is too small, then material will be fused between the sides of the hole.
    I'm considering the Strong & Flexible Plastic.

    Cheers.
     
  2. JACANT
    JACANT Well-Known Member