FUD to mold to sterling silver

Discussion in 'Finishing Techniques' started by A_Square, Feb 6, 2012.

  1. A_Square
    A_Square New Member
    This is a cross-post with "It arrived!" but I figured it was of interest here, too.

    I used FUD prints to make rubber molds, and then used those molds to produce wax positives for casting in sterling silver. I'm very happy with the results! This process is a lot more work than printing directly in silver, but its much cheaper (especially for making multiples), it easily allows multi-part pieces without having to pay the startup costs for each one, and overall allows a lot more control.

    I wrote more about the process in a blog post here:
    http://upnotnorth.net/2012/02/06/question-block_and_crowbar/

    View attachment 14326
    View attachment 14327
     
  2. DoWhileGeek
    DoWhileGeek New Member
    I'm getting flashbacks from Half Life. :p