Frosted detail design guidelines inconsistent

Discussion in 'Bug Reporting' started by tebee, Nov 13, 2013.

  1. tebee
    tebee Well-Known Member
    Just had a model rejected because a part sticking out was 0.62mm thick and and on checking it does indeed now say -

    Min Wire Free: 0.8mm (if not bearing weight)

    But a little further down, under "Parts that jut out are more likely to break during shipping" it says -

    "Alternatively, you can thicken the wires that jut out to 0.6-0.8mm thick."


    I presume this has been missed in one of the updates to the guidelines - like I missed the specification for wires had changed too !


    Tom
     
    Last edited: Nov 13, 2013
  2. Youknowwho4eva
    Youknowwho4eva Shapeways Employee Community Team
    Thanks Tebee, I've forwarded it on to be fixed.