first upload? makeable?

Discussion in 'My Work In Progress' started by 3dmIlky, May 21, 2013.

  1. 3dmIlky
    3dmIlky New Member
    Last edited: May 21, 2013
  2. Youknowwho4eva
    Youknowwho4eva Shapeways Employee Community Team
    Are your faces enclosed? If they weren't enclosed, the automated software would try to enclose them. Pretty much what you see is what you would expect to get. As long as you follow the guidelines for the intended material.
     
  3. 3dmIlky
    3dmIlky New Member

    Thanks for answering.
    I think yes, they are enclosed. Up to the cap of the box. Is it ok to put two parts in one print?

    Andy
     
  4. Youknowwho4eva
    Youknowwho4eva Shapeways Employee Community Team
    What's your intended material? If you go through the material guidelines pages, it tells you if multiple pieces are allowed for that material.
     
  5. AmLachDesigns
    AmLachDesigns Well-Known Member
    Because SW charges by volume for all materials except Ceramic.

    Your box is large for a SW object and the walls are thick. If you go to your Model page and Edit it it will tell you the Volume. Then you can use the prices on the Materials pages to figure out the cost.
     
    Last edited: May 21, 2013
  6. 3dmIlky
    3dmIlky New Member
    thx a lot for the moment :rolleyes: