Error Messages

Discussion in 'Bug Reporting' started by calli, Aug 1, 2008.

  1. calli
    calli New Member
    This is not a helpfull message at all:

    Code:
    We're sorry, but there was a problem with processing your 
    model called 'AllyN': it didn't pass the checks that we run to make 
    sure a model is printable. Here's the error message; it may help 
    you determine what went wrong:
    
    The model could not be validated.
    
    :eek:

    Best Regards,
    Carsten :twisted:
     
    Last edited by a moderator: Aug 1, 2008
  2. bartv
    bartv New Member
    Hey Calli,

    yeah, we're aware of that - the next release of our website is almost ready and those messages have been much improved.

    Thanks!

    Bart
     
    Last edited: Aug 1, 2008
  3. calli
    calli New Member
    Hi Bart!

    Very good, so far I start on experimenting how to get a modell uploaded and validated.

    Thanks,
    Carsten
     
  4. calli
    calli New Member
    I did try with STL which failed.

    Now with X3D it worked, I guess it was a scaling was not correct.

    Now the modell is rotated, is it better to have a modell upright (so rotating it in Blender) or flat? Its a figure.

    Carsten
     
  5. bartv
    bartv New Member
    Hey Calli,

    the issue with STL is that we're currently interpreting one STL unit as 1m, which is unconventional. Our next release will address that, too.

    The orientation of the models really doesn't matter for production - all parts are re-oriented for optimal print results.

    Cheers,

    Bart

    PS: I've added some line breaks to your original post as it messed up the page layout.
     
    Last edited: Aug 1, 2008
  6. calli
    calli New Member
    Thanks Bart!

    Carsten