Distortion on printed WSP part ?

Discussion in 'Technologies and Hardware' started by pjrebordao, Apr 29, 2009.

  1. pjrebordao
    pjrebordao New Member
    I've just received my first part made of WSF, and on a first inspection I have a couple questions that some of you might be able to answer...

    - the part is slightly distorted (bent) in one of the axes. About 1mm on a 160mm length. Is that to be expected as part of the process and the achievable precision, or it just didn't turn out completely Ok ???
    - Also, the model had a hole with a 1mm diameter, and it didn't came out. Was it too small ?