Design Printability Validation Service

Discussion in 'Bug Reporting' started by B1lancer, Nov 11, 2009.

  1. B1lancer
    B1lancer New Member
    Quite a few models I produce I want myself so I am happy to buy the initial test print, however some I don't want and I end up printing a test model that I don't really want just to make sure the customer won't get the "Model too thin to print" error etc. Normally it's an error I can correct in a couple of mins.

    What I'd like is a service which costs maybe $10-15 where your model is sent to the operators and they check to see if it will print and then send you a confirmation telling you the model will print without any problems or if problems are found how to rectify them followed by a re-check.

    Kindest Regards, Jack