Clip With Frosted Extrem Detail

Discussion in 'Materials' started by Arkhan, Jul 15, 2017.

  1. Arkhan
    Arkhan Member
    Hi,

    I'm modeling an M2 mortar and I wish to make the legs part mobile and removable from the tube part
    And I wish to know if it's possible to make a clip with Frosted Extrem Detail material
    I have make the bar circumference slightly smaller than the circumference of the clip.

    clip_.png

    Thanks in advance
    Kind regard
    Arkhan
     
  2. Shea_Design
    Shea_Design Well-Known Member
    Of course you can make it, print it, but will it work? I would characterize FUD/FED as somewhat brittle, meaning it will flex some then break. Of course I'm shooting in the dark without knowing the scale. Upload and share a model check when you get to it. -S
     
  3. Arkhan
    Arkhan Member
    Last edited: Jul 15, 2017
  4. Shea_Design
    Shea_Design Well-Known Member
    A model check occurs after upload and can be shared without compromising your 3D property (link on the model page). The heat map and other tools will show you if your parts are within specification. I imagine 1/18th is pretty small so flex may not be much of an issue. I tried to load your model and link it back to you but the upload failed. -S