breaking risk

Discussion in 'Technologies and Hardware' started by Anasrafiq, Feb 18, 2013.

  1. Anasrafiq
    Anasrafiq New Member
    lean02.jpg Hello

    Is there any possiblity to know if my model is safe from breaking or any damage if i print in stainless steel (gold plated finish)
    Its dimentions are :cm: 3.03 w x 5.514 d x 9.412 h in: 1.193 w x 2.171 d x 3.706 h
    If not i think the only choice i will have is printing it in frosted details, and strong&flexible platic

    Thank you
     
  2. stonysmith
    stonysmith Well-Known Member Moderator
    Brim of the hat, the fingers, possibly the area below the pockets on the front of the coat.. I would expect all of those to be rejected.

    They don't appear to be thicker than the absolute minimum of 1.5mm