big WSF printer

Discussion in 'Technologies and Hardware' started by flat_twelve, Nov 20, 2010.

  1. flat_twelve
    flat_twelve New Member
    Hi,

    I just received prints in WSF. they are from models i had previously had printed in WSF. They were sized to fit in the limits of that printer an I know there was only one way it would fit in it. Though the new prints i got are not printed in the same orientation and the quality of the print is not as good as the first print i had. So I conclude that they were printed on the new big WSF printer, which, if i understood well does have a 0,5 instead of 0,2 mm minimum detail.
    am I right?
    someone else had that issue?
    and to shapeways team: can you explain

    thanks


     
  2. bitstoatoms
    bitstoatoms Member
    Hey Flat-twelve

    Please send an email to service (at ) shapeways.com and they will be able to answer your questions.

    cheers