Autodesk Inventor Export to .stl

Discussion in 'Software and Applications' started by Ottobot, Mar 23, 2011.

  1. Ottobot
    Ottobot New Member
    I am trying to export a complete part that I have modified in Autodesk Inventor and just can't get it to work. It is only exporting the top of my part when I want to export the entire .ipt file to print at Shapeways. I have read lots of tutorials and tried to use assembly and Shrinkwrap, but I just can't figure it out. Does anyone know how to combine all of the parts in the attached .ipt file and export them as an .stl file?

    Thank you very much for any help you might be able to provide.

    - Jos
     

    Attached Files:

  2. Youknowwho4eva
    Youknowwho4eva Shapeways Employee Community Team
    If you can export a dwg I may be able to help you get the file up. Can't help you with your exporting issues though.
     
  3. Ottobot
    Ottobot New Member
    Thanks for the response, but I JUST figured it out. After spending hours and hours working on it, I was able to get it working minutes after finally posting a request for help. Of course, that would be how it would happen.

    - Jos
     
  4. Youknowwho4eva
    Youknowwho4eva Shapeways Employee Community Team
    :laughing: That's how it usually works.