And yet another (couple of) DIY printer(s)

Discussion in 'General Discussion' started by stannum, Nov 16, 2011.

  1. stannum
    stannum Well-Known Member
  2. 90aa749bb3
    90aa749bb3 New Member
    It is not in the Building phase. It is past that into the testing phase.

    3DLPrint
     
  3. dizingof
    dizingof New Member
    ;)

    I actually gave him some pointers on some manufactures of low cost , low viscosity UV curing resins i tested, on that instructables page - hopefully he'll test them on his prototype.

    It will take some time before we can see a DIY, resin-based 3d printer kits..
    Another developer is rumored to have gone closed-source on his very anticipated 3d printer and thats too bad.
    http://3dhomemade.blogspot.com/


    Until then i ordered the HuxelyPro which has extremely convincing 0.1mm layer height and according to NetFabb - makers of a commercial software for these printers they can make these reprap models go even 40 or 20 micron (!) resolution... - demo of such quality can be seen on thingverse.com






     
    Last edited: Dec 7, 2011