Add A Suction Cup To A 3d-printed Design

Discussion in 'General Discussion' started by armyofda12mnkeys, May 17, 2018.

  1. Hello everyone!,
    First post here.
    I made my first 3d design and had it 3d printed, yay.
    I realized that adding a suction-cup to the design would help so the object doesn't get knocked off as easily off countertops.
    I was wondering how should i approach this. I don't mind buying the suction cup in bulk elsewhere and then add it to my designs. But not sure what kind of mechanism I should use to cone.

    Like if i bought this Uline one:
    https://www.uline.com/Product/Detai...U4kn-kzfIJzdSQzZqRgaAnYVEALw_wcB&gclsrc=aw.ds
    I'm not sure how I could connect a 3d design to that.

    I also floated idea of using an adhesive under the 3d printed design, but then could only use it once.
    Any ideas?

    Thanks!,
    Ari