A few questions about scaling

Discussion in 'Technologies and Hardware' started by ConnorA, Mar 6, 2014.

  1. ConnorA
    ConnorA New Member
    Hi there, quite new to this all so if the answers are obvious, I apologise in advance!

    I'm done with my design, have checked it's watertight with AccuTrans and am on the final stages. Just have a few questions about scaling:

    1. How is the scaling measured? (i.e cm, inches, bananas)

    2. Is there a program other than AccuTrans that can present the scaling in a slightly more user friendly manner?



    For reference, I've modelled using Zbrush 4r6.

    Thanks,
    Connor
     
  2. MitchellJetten
    MitchellJetten Shapeways Employee CS Team
  3. ConnorA
    ConnorA New Member
    Thanks, that's exactly what I was looking for! And a pretty speedy response might I add.

    Now I just have to decide what scale to actually use!

    Thanks again,
    Connor